Ici, nous échangeons sur les produits ZiGate (matériellement) et les firmware.
Pour que vous puissiez gagner du temps, je vous conseille de visiter, dans un premier temps, les forums et documentations des plugins et box domotique que vous avez choisi :
Received the PiZiGate this week and started right away. After a few attempts, I was able to test the Pizigate but the result was 'Error 11'.
There was also no change in (blue) light intensity.
Results of PiZiGate Test:
pi@raspberrypi:~/PiZiGate-tools/test $ sudo ./PiZiGate_test /dev/ttyAMA0
RPI Model searching ...
Warning !!! you must modify /boot/config.txt
Verifying /boot/cmdline.txt ...
+ /boot/cmdline.txt seems to be OK
Verifying /boot/config.txt ...
+ /boot/config.txt seems to be OK
Warning !!! if it's not the case, you have to execute the following commands :
sudo systemctl disable hciuart
sudo usermod -aG gpio pi
then reboot the PI
Searching /dev/ttyAMA0...
+ Port : /dev/ttyAMA0 is not used
Verif GPIOs ...
+ GPIO 0 (RESET) --> OK
+ GPIO 2 (FLASH) --> OK
Config GPIOs ...
+ GPIO 0 (RESET) --> OK
+ GPIO 2 (FLASH) --> OK
Opening : /dev/ttyAMA0 ...
+ /dev/ttyAMA0 opened --> OK
+ Packet 01 02 10 10 02 10 02 10 10 03 sent --> OK
- No packet received - size sent : 11 - error : 11
Please help
Regards, Jeroen
Hello,
Received the PiZiGate this week and started right away. After a few attempts, I was able to test the Pizigate but the result was 'Error 11'.
There was also no change in (blue) light intensity.
Results of PiZiGate Test:
pi@raspberrypi:~/PiZiGate-tools/test $ sudo ./PiZiGate_test /dev/ttyAMA0
RPI Model searching ...
Warning !!! you must modify /boot/config.txt
Verifying /boot/cmdline.txt ...
+ /boot/cmdline.txt seems to be OK
Verifying /boot/config.txt ...
+ /boot/config.txt seems to be OK
Warning !!! if it's not the case, you have to execute the following commands :
sudo systemctl disable hciuart
sudo usermod -aG gpio pi
then reboot the PI
Searching /dev/ttyAMA0...
+ Port : /dev/ttyAMA0 is not used
Verif GPIOs ...
+ GPIO 0 (RESET) --> OK
+ GPIO 2 (FLASH) --> OK
Config GPIOs ...
+ GPIO 0 (RESET) --> OK
+ GPIO 2 (FLASH) --> OK
Opening : /dev/ttyAMA0 ...
+ /dev/ttyAMA0 opened --> OK
+ Packet 01 02 10 10 02 10 02 10 10 03 sent --> OK
- No packet received - size sent : 11 - error : 11